首页 | 本学科首页   官方微博 | 高级检索  
     检索      

基于图像传感器的片烟规格测量方法
引用本文:李志阔,孟志永,魏泽鼎.基于图像传感器的片烟规格测量方法[J].河北工业科技,2011,28(3):208-211.
作者姓名:李志阔  孟志永  魏泽鼎
作者单位:1. 河北科技大学机械电子工程学院,河北石家庄,050018
2. 河北科技大学电气信息工程学院,河北石家庄,050018
摘    要:针对传统工艺对打叶后片烟面积的检测和分类方法的缺点,提出了基于图像传感器的片烟规格测量方法.由CMOS图像传感器采集工作台上的片烟图像信息,并以统一的亮度阈值对图像进行二值化处理;然后采用硬件方法提取二值图像的边界信息,再根据连续区段标记算法统计出各个连续区域的面积,进而最终得到各个面积段片烟的比例.实验证明该测量方法...

关 键 词:CMOS图像传感器  单片机  片烟  二值化图像  连续区段
收稿时间:2011/1/12 0:00:00
修稿时间:2011/3/11 0:00:00

Measurement of strips size based on image sensor
LI Zhi-kuo,MENG Zhi-yong and WEI Ze-ding.Measurement of strips size based on image sensor[J].Hebei Journal of Industrial Science & Technology,2011,28(3):208-211.
Authors:LI Zhi-kuo  MENG Zhi-yong and WEI Ze-ding
Institution:1(1.College of Mechanical and Electronic Engineering,Hebei University of Science and Technology,Shijiazhuang Hebei 050018,China;2.College of Electrical Engineering and Information Science,Hebei University of Science and Technology,Shijiazhuang Hebei 050018,China)
Abstract:For the shortcomings of the traditional processes of strips area measurment and classification,a method for strips size measurement based on image sensor was put forward.The image information of the strips on the working platform was scanned by CMOS image sensor and binary processing is implemented under an uniform threshold value directly.Then the edge information of the binary image was extracted by hardware method.Area of each successive sections were computed by connected component labeling algorithm.Finally the proportions of every span of strips area were obtained.The experiment result proves that the method is accurate and reliable.The relative error of the result is less than 2%.Meanwhile it has a good real-time performance,which provides a reference for fast adjustment of the threshing process parameters.
Keywords:CMOS image sensor  MCU  strips  binary image  successive section
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《河北工业科技》浏览原始摘要信息
点击此处可从《河北工业科技》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号