共查询到20条相似文献,搜索用时 47 毫秒
1.
生活污水和工业废水成分复杂,其中含有的各种干扰物质会使水样带色或浑浊,影响氨氮的测定,为此在分析时需作适当的预处理。现通过实验,对不同类型水样分别采用取絮凝沉淀(取上清液、过滤、离心)、蒸馏等方法进行预处理,通过比较不同预处理方法下纳氏试剂比色法氨氮测定结果,分析各种预处理方法对污水中氨氮测定结果的影响。 相似文献
2.
3.
4.
乳化后的含油污水中,油滴细小分散、稳定不易团聚上浮。常规采用药剂破乳和加热处理方法,会增大企业生产成本。柱状气浮除油技术因其设备结构简单、节能高效,无二次污染等优点受到相关企业重视。气浮除油效率受到多种参数制约,而压力、分流比、污水的矿化度和单位时间内的气浮强度是几个关键因素。该文以实验研究为主,提出了综合除油率和气浮强度两个评价指标。尝试在实际生产环境内的可控制因素中,找到影响气浮除油效率的关键因素,用以改进柱状气浮分离工艺。 相似文献
5.
6.
7.
8.
超滤膜和微滤膜在生活污水回用处理中的应用研究 总被引:2,自引:0,他引:2
主要针对经二级生物处理后的机场污水 ,使用膜处理的方法进行深度处理 ,以期达到污水回用的目的。回用水的水质指标按照生活杂用水指标来执行。试验通过使用孔径为 0 2 5μm的中空纤维聚丙烯腈微滤膜和切割分子量为 1 0 0 0 0的中空纤维的聚砜超滤膜 ,对机场污水进行了试验及结果分析 ,同时为使试验数据具有普遍意义 ,还对北石桥污水处理中心的出水和兴庆湖入口处水样作了对比试验。试验流程如下 :超滤 :原水→格栅→原水泵→保安过滤器→超滤膜组件→滤后水 (浓缩水 )微滤 :原水→格栅→原水泵→微滤膜组件→滤后水 (浓缩水 )主要结论如… 相似文献
9.
11.
含毒有机废水生物处理前的预处理 总被引:5,自引:0,他引:5
生物处理是污水处理的一种重要处理方法 ,但它易受毒物的影响和破坏。介绍了毒物对微生物的 7种作用机制 ,以及建立在菌种驯化法基础上的 3种应对措施 :①稀释法 ;②转化法 ;③分离法。 相似文献
12.
13.
概括介绍了现代公共建筑中餐饮废水的水质特点及处理要求,并结合公共建筑餐饮废水处理工艺的特殊性,对混凝法、生物法、电化学法等一些处理工艺及工程应用实例进行了综述.认为具备一体化、体积小、占地少、噪音低、处理效果好、运行管理方便等特点的新型餐饮废水处理技术将得到广泛的应用. 相似文献
14.
佳木斯东区污水处理厂SBR工艺的低温快速启动 总被引:1,自引:0,他引:1
为在低温(水温14℃)下完成佳木斯东区污水处理厂SBR工艺的快速启动,采用复合生物茵剂、粪便水和活性污泥同时投加、先异步后同步的复合培茵方法对污水处理厂进行了调试.结果表明,该方法可有效克服低水温、贫营养、缺水、跑泥等问题对启动过程的不利影响,在进水CODCr、NH3-N和TP分别在140~430 mg/L、20~40 mg/L和2~3 mg/L大幅度波动的情况下,实现出水的快速持续达标,平均出水浓度分别为42.1 mg/L、6.4 mg/L和0.9 mg/L,满足了<城镇污水处理厂污染物排放标准>(GB 18918-2002)中一级A标准. 相似文献
15.
有限元法前处理技术的发展 总被引:4,自引:0,他引:4
论述有限元前处理技术的发展过程和主要方法 ,并以行波法生成三角形单元和合成法生成四边形单元的主要过程为例 ,系统地阐述有限元网格自动生成过程的一般步骤 ,网格优化及单元质量评价方法 ,并展望有限元前处理技术的发展趋势 .分析表明 ,合成法生成四边形单元具有单元质量好 ,边界适应性强 ,适于自动生成等优点 . 相似文献
16.
表面活性剂类废水处理工程 总被引:5,自引:0,他引:5
南京某化学有限公司采用煤渣吸附 -絮凝沉淀 -泡沫分离的工艺处理表面活性剂类废水 ,经实践运行证明其出水水质优于国家排放标准 ,且具有操作方便、处理效果好、自动化程度高等特点。 相似文献
17.
18.
19.
Wastewater from an Akzo Nobel production site contains more than 50 g/l total dissolved salts, mainly chlorides and sulphates, and is currently being treated after 10-20 x dilution. Biological treatment of undiluted or less diluted wastewater is very desirable for environmental and economic reasons. Possibilities were investigated in laboratory scale reactors to treat this highly saline and high strength wastewater aerobically, either after long adaptation or after removing part of the salts by a pretreatment. Adaptation and selection from mixed activated sludge populations took approximately 40 days to finally achieve a COD removal in aerobic treatment of 55-65% at two times dilution (11-16 g/l chloride and 5-7 g/l sulphate). Undiluted wastewater was not treatable. A higher removal percentage (> 80%) was possible at the original high salt concentration only when the sludge load was limited to approximately 0.4-0.5 kg COD/kg sludge/day. A longer adaptation time was required. Nanofiltration (NF) and crystallization could be used as a pretreatment to remove and recover up to 80% of the sulphate in the form of crystallized Glauber salt. Recovery strongly depended on the sulphate and chloride concentration in the NF concentrate and on crystallization temperature. The salt (sulphate) reduction through the NF improved the removal efficiency of a consecutive biotreatment only at a relatively low chloride level, demonstrating that the combination of nanofiltration-crystallization-aerobic biodegradation is less feasible for very saline wastewaters. Anaerobic pretreatment of saline waters turned out to be rather sensitive to high salinities. Only wastewater diluted to 10 g/l chloride could be treated well: sulphate concentration decreased by 80% and COD by 40%. Removal efficiencies of the combined anaerobic-aerobic treatment were approximately 80-85%, proving that this was a feasible route for 2-3 x diluted wastewater. The study has shown that several alternatives are available for treatment of the very saline wastewaters at a much lower degree of dilution than currently practiced. 相似文献
20.