基于多维产出ZSG-DEA模型的中国水资源污染综合分配效率测算

利用考虑多维产出的零和收益-数据包络分析(ZSG-DEA)模型测算2000—2017年中国大陆31个省级行政区(以下简称省)在水资源污染排放总量固定下的污染综合分配效率及生产、生活与生态3个维度的产出效率,并基于效率最大化原则对2017年各省污染排放额度进行调整。结果表明:31个省污染综合分配效率的平均值由2000年的0.322上升至2017年的0.364,生产维度产出效率是拉动污染综合分配效率提升的主要动力;2000—2017年31个省污染综合分配效率的平均值为0.341,生态产出过量与生活维度产出不足导致污染综合分配效率处于较低水平;污染综合分配效率、生态维度产出效率与生活维度产出效率受经济发展水平影响较小,而生产维度产出效率受经济发展水平影响较大;污染综合分配效率分布由大到小为东部、西部、中部,生产维度产出效率分布由大到小为东部、中部、西部,生态维度产出效率分布由大到小为西部、中部、东部,生活维度产出效率分布由大到小为西部、东部、中部;各省污染排放调整额度与污染综合分配效率呈正相关关系,北京、天津、上海、浙江、青海与西藏等20个效率较高的省可增加污染排放额度,河北、安徽、河南、江西与湖北等11个效率较低的省需降低污染排放额度。     

Modeling air flow in sanitary sewer systems: A review

Current designs of sanitary collection systems normally only consider the transport of wastewater without attention on the air movement in the sewer airspaces. Under anaerobic conditions, hydrogen sulfide (H₂S) can be generated in the liquid phase in sewer systems. H₂S is corrosive to concrete and steel structures and odorous or even toxic to human, which can cause corrosion and sewer odor issues. To develop a feasible sewer corrosion and odor control strategy, it is necessary to understand the mechanisms of air flow in sewer systems for developing practical tools to predict and control the air flow. This paper comprehensively reviewed previous efforts on modeling the air flow in sewer systems and provided recommendations on predicting the air flow for engineering applications. The air flow in a single pipe was firstly reviewed followed by the air flow in sewer structures as well as air flow models in sewer networks. Some other considerations such as temperature driven flow, transient water flow, and wind effect were also reviewed. The knowledge gaps were then identified, and recommendations on the further studies were provided.     

Comparison of infiltration models to describe infiltration characteristics of bioretention

Bioretention is one of low-impact development measures, which widely used not only because it can reduce stormwater runoff total volume, decrease peak flow rate and delay peak flow time, but also can remove the runoff pollutants. Infiltration is an important hydrological process for bioretention to evaluate its runoff total volume reduction and pollutants removal. So, it is important to find an optimal infiltration model that can well describe the infiltration performance of bioretention. The Horton, Philip and Kostiakov infiltration models were selected to compare their accuracy when using for describe the infiltration characteristics of bioretention, and the errors between the different models simulate results and experiment results were assessed via the maximum absolute error (MAE), bias and coefficient of determination (R²). The experimental results showed that Horton model is fitting well and flexible under different experiment conditions, especially when the hydraulic head was 10 cm, with MAE of 0.50–0.81 cm/h, bias of 0.1–0.23 cm/h and R² of 0.98–0.99. R² of the Philip and Kostiakov models were all over than 0.87 at the initial infiltration period, but the model fitting accuracy decreased significantly with infiltration time elapse. Furthermore, the total runoff volume capture ratio and emptying time were advanced used to evaluate the flexibility of Horton model, and the Nash-Sutcliffe efficiency coefficients of them were over than 0.61 and 0.58, respectively. Therefore, the Horton model can be optimal selected to describe the infiltration process of bioretention and for its hydrological evaluation.     

基于统一硬化参量的海洋K0固结土动力本构模型

为方便海洋工程中桩土相互作用计算,根据海洋K₀固结土体特性,对现有相关土体本构模型进行简化。在修正剑桥模型的基础上,基于热力学理论,选用耗散功作为硬化参量,结合原状土体的固结属性,推导了适用于黏土与砂土的统一硬化模型。在此基础上,通过采用旋转硬化与等向硬化相结合的硬化理论来表征K₀固结土在循环荷载作用下的硬化规律,同时引入屈服面收缩参数Θ来描述循环荷载加载过程中土体屈服面的演化特性,进而建立了循环荷载下海洋K₀固结土体统一硬化模型。为验证本文提出的本构模型的合理性,开展了2个案例的对比研究,研究结果表明:新提出的统一硬化模型的计算值与实测值吻合,选用的计算参数少且物理意义明确。     

黄河干流白银市水川段水面线计算方法对比分析

为克服能量方程逐段试算方法在河道水面线计算上存在的不足与局限,本文以黄河干流白银市水川段为例,采用二维水动力数值计算模型,对4种洪水频率工况下黄河干流白银市段的水面线高程进行计算,并将二维数值计算结果与能量方程计算结果进行复核和评价。经计算可知两种计算方法在计算结果上存在偏差,能量方程在河道水面线计算上是一种近似成果,而二维数值计算能够更加真实反映河道的实际情况,因此在水面线计算时推荐二维数值计算方法。     

水源涵养内涵及估算方法综述

水源涵养和生态系统过程与人类生产生活紧密相关,深入研究水源涵养对维持生态系统健康和人类社会可持续发展至关重要,对促进人与水和谐共生具有指导意义。随着对水源涵养研究与应用的深入,水源涵养内涵逐渐丰富,评估方法愈加多样,但以往的研究中水源涵养定义模糊,缺乏对各种评估方法的综合性对比分析,因此急需明确界定水源涵养内涵,分析各种估算方法的适用性。采用文献分析法系统梳理水源涵养研究历程,将其划分为认识与萌芽期、理论发展期、定量计算和模型综合评估等4个阶段;从定义、水量与功能等3个方面明确界定水源涵养内涵,从原理、时空尺度、适用范围及优缺点方面对已有水源涵养量估算方法进行对比和分析,并展望水源涵养研究的未来发展方向。     

基于关键闸坝优选的区域水网水量调控

为实现区域水网水量的高效调控,从水量、水生态、水质和闸坝管理等4个方面构建包含10个指标的闸坝优选评价指标体系,以廊坊市凤河-永定河区域水网为研究对象,计算区域内32座闸坝的综合关键指数并给出影响程度排序,采用水动力数学模型验证关键闸坝选取的合理性。结果表明：优选出的永丰闸和东张务闸是区域水网的关键闸坝,通过调节这两座闸坝的开度即可满足区域水网的生态需水和防洪排涝调度目标,保持区域水网较优的水力连通能力,提高区域水网水量调控效率。     

妫水河入官厅水库水污染成因及减排措施评估

为保障妫水河入官厅水库入流水质达标,分析水质成因,分步制订水质改善措施。采用MIKE21耦合植物作用的Ecolab生态水质模型,对妫水河下游入官厅水库断面至东大桥断面、支流三里河水域进行模拟。通过对丰水期和枯水期监测数据及模拟结果进行分析,流域上游来流水量及水质、区间污染源及河流湿地等自净作用是影响官厅水库入流水质的主要原因,其中:妫水河入流污染负荷对水库入流水质贡献率最大,丰枯水期氨氮、总磷和总氮的贡献率分别为18.32%～45.76%、9.31%～31.17%和29.34%～67.56%;区间入河污染源氨氮、总磷和总氮削减率分别为19.41%、31.31%和24.94%;丰枯水期河道自净对氨氮、总磷和总氮削减率分别为44.85%～61.29%、51.40%～77.92%和8.40%～23.06%。为改善官厅水库入流水质,在流经城市区的妫水河下游及三里河修建了河流湿地公园,对区域污染源进行截污,使得入库水质可达到Ⅲ类水。为长远确保官厅水库的水质,控制来流水质和加强流域治理是关键,同时营造岸带湿地,对水质改善有积极的作用。研究结果及方法可为水库污染防治及负荷量削减提供理论依据。     

R&D项目投资评估的实物期权方法初探

本文分析了传统的NPV法在R&D项目投资评估中的缺陷,指出R&D项目投资本质上所具有的期权特性。在此基础上引入了实物期权方法,包括Black-Scholes期权定价方法和Geske期权定价模型。     

工程建设PM、CM和PMC三种模式的比较

PM、CM和PMC是三种不同的工程建设模式,产生于不同的历史阶段和市场条件,有着各自的特点和适用范围。文章介绍了三种模式的基本含义及特征,在组织、合同、工作范围以及风险和责任等方面进行了比较研究,并对三种模式的优势和适用条件进行了分析,最后强调在应用时,应根据项目的不同情况和条件来加以选择。