连云港海域悬沙和表层沉积物交换研究

采用粒度谱计算方法分析连云港及邻近海域悬沙和表层沉积物交换特征,为徐圩防波堤口门布置和连云港港航道回淤研究提供理论支撑。连云港港主航道和徐圩航道5 m等深线以外的区域悬沙和表层沉积物交换率为0.1~0.2,表明航道回淤强度将处于较低水平,对今后航道维护有利;5 m等深线以内区域的交换率为0.3~0.4,悬沙落淤对航道回淤有一定贡献,表明该航道段回淤量相对较大,计算结果与实测航道回淤强度分布特征基本一致。灌河口沙嘴正常天气条件下交换率小于0.2,说明悬沙落淤对沙嘴的影响较小;5 m等深线以内破波带水域交换率大于0.5,表明悬沙和表层沉积物交换频繁。连云港港及邻近海域悬沙和表层沉积物交换主要为粒径小于62 μm的细颗粒组分。分析结果表明,为减少泥沙回淤对徐圩港区港池正常运行的影响,兴建防浪挡沙堤并将堤头布置在破波带之外十分必要。     

Estimating discharge in gravel‐bed river using non‐contact ground‐penetrating and surface‐velocity radars

Discharge measurement is a critical task for gravel‐bed channels. Under high‐flow conditions, the elevation of the riverbed changes significantly by intensive torrential flow. The stage–discharge relations commonly used for stream discharge estimation may no longer be adequate. The contact‐type velocity measuring is also subject to measurement errors and/or instrument failures by the high‐flow velocities, driftwood, stumps, and debris. This study developed a new real‐time method to estimate river discharge in gravel‐bed channels. A systematic measuring technology combining ground‐penetrating radar and surface‐velocity radar was employed. The rating curves representing the relations of water surface velocity to the channel cross‐sectional mean velocity and flow area were established. Stream discharge was then deduced from the resulting mean velocity and flow area. The proposed method was examined in a steep gravel‐bed reach of the Cho‐Shui River in central Taiwan. The estimated stream discharge during three flood events were compared to the prediction by using the stage–discharge relation and the index‐velocity method. The proposed method of this study is capable of computing reasonable values of discharge for an entire flood hydrograph, whereas the other two methods tend to produce large extrapolation errors. Moreover, when the computed discharge is used in 2D flood flow simulation, the proposed method demonstrates better performance than the commonly used stage–discharge and index‐velocity methods.     

改进的蚁群算法在溶质运移参数识别问题中的应用

非饱和土壤水分和溶质运移参数(扩散率、导水率和水动力弥散系数)取值范围较大,往往跨越几个数量级。采用传统离散化蚁群算法求解此类问题,所需节点较多,这会造成算法收敛时间较长。该文在传统蚁群算法基础上,对蚂蚁搜索路径进行改进,改进后的蚁群算法寻优路径由参数精度位数(整数位和小数位)、参数个数以及0–9十个数字构成,并将路径解码公式修改为具有判别参数正负功能的解码公式。采用改进的连续蚁群算法对非饱和溶质运移参数识别优化模型进行求解。数值模拟表明相同迭代次数下改进的蚁群算法比传统蚁群算法耗时少,算法计算时间与迭代次数满足线性关系,含水率和溶质浓度实测值与计算值吻合较好、相关性较高。     

落水洞对裂隙-管道介质泉流量衰减过程影响的试验研究

岩溶裂隙-管道是我国西南地区的主要地下储水空间和导水通道,落水洞是岩溶地区临时性吸收地表水流的重要过水通道,在西南地区分布密集。开展落水洞大小对裂隙-管道介质中泉流量过程影响的研究,对指导岩溶水可持续开发利用和推动岩溶水研究具有深刻意义。文章研究了落水洞对泉流量衰减过程的影响,利用自制的裂隙-管道物理模型,模拟落水洞不同断面尺寸、填充程度下的泉流量衰减过程,由衰减曲线探求衰减系数受不同因子的敏感程度。试验表明:泉流量衰减过程可分为三个亚动态,大致符合指数型衰减。其中,第一亚动态的衰减系数受落水洞断面尺寸影响较大,落水洞断面尺寸越小,衰减系数越大;落水洞的填充程度越高,衰减系数越大。     

快速闸门断流的轴流泵起动过程三维数值模拟

针对轴流泵机组起动过程的研究是泵站安全稳定运行研究的重要环节。为了准确捕捉轴流泵机组在起动过渡过程中的动态特性,建立轴流泵机组的全流道三维模型,采用三维CFD计算软件Fluent,利用基于有限体积法的动网格技术,配合VOF多相流模型对快速闸门断流的轴流泵机组起动过程进行了三维瞬态数值模拟,获得了轴流泵机组起动过渡过程中的流态变化及外特性参数的变化规律。闸门开启时间为60s时,机组起动扬程在12s时达到最大值2.76m,为运行扬程的1.28倍。减小快速闸门开启时间能够降低机组最大起动扬程,但同时会加剧回流及闸门处的水流撞击。计算结果表明:动网格技术结合VOF多相流模型可以较好的应用于快速闸门断流的轴流泵机组起动过渡过程数值模拟中,其结果可为泵站水力设计及轴流泵机组的过渡过程研究提供参考。     

植被排列方式及坡度对坡面流Fr影响的试验研究

为探究植被的排列方式及坡度大小对坡面流弗劳德数Fr的影响,以期揭示坡面流弗劳德数Fr的内在规律。利用人工模拟试验,系统研究了6个坡度、3种植物排列方向与水流方向呈不同走向角的条件下Fr与单位底面积的空间摩阻表面积K值的特征关系。表明在非淹没状态下,Fr与K值的关系为随K值的增大Fr呈现先减小后趋于平稳的趋势;Fr的取值随坡度的增大而增大;在一定的坡度范围内,同一坡度下,当Fr1时,同一K值下,走向角越大对应的Fr值越小,当Fr1时则相反;同一走向角下,在同一K值下,坡度越大对应的Fr就越大。得出在坡度一定的条件下,坡面植被的排列方式不同,弗劳德数Fr的取值也不相同;坡度是影响Fr取值范围的重要因素之一。     

Benchmarking Fluvial Dynamics for Process‐Based River Restoration: the Upper Rhine River (1816–2014)

Multi‐temporal analysis of river‐floodplain processes is a key tool for the identification of reference conditions or benchmarks and for the evaluation of deviations or deficits as a basis for process‐based river restoration in large modified rivers. This study developed a methodology for benchmarking fluvial processes at river segment level, focusing on those interrelations between morphodynamics (aggradation, erosion, channel shift) and vegetation succession (initial, colonization, transition) that condition habitat structure. Habitat maps of the free‐flowing Upper Rhine River downstream from Iffezheim dam (France–Germany border) were intersected with a geographic information system‐based approach. Patches showing trajectories of anthropization, changeless, progression and regression allowed for the identification of natural and human‐induced processes over almost 200 years. Before channelization, the riverine system was characterized by a shifting habitat mosaic with natural heterogeneity, high degree of surface water connectivity and equilibrium between progression and regression processes. On the other hand, the following 175 years of human interventions led to severe biogeomorphologic deficits evidenced by loss of natural processes and habitat heterogeneity, hydrological disconnection between the river and its floodplain and imbalance of progression versus regression dynamics. The main driving forces of change are found in hydromorphological impacts (channelization, regulation and hydropower plant construction). Regression processes are now almost absent and have to be the objective of process‐based river restoration measures for the studied river‐floodplain system. A sustainable view on water management and river restoration should aim at a more resilient riverine system by balancing the recovery of natural processes with societal needs. Copyright © 2016 John Wiley & Sons, Ltd.     

塔里木河干流人工与天然绿洲转化及适宜比例研究

利用1990,2000,2010年3期Landsat TM/ETM遥感影像,基于RS/GIS技术,分别提取土地利用/覆被类型信息,分析1990~2010年塔里木河流域人工绿洲和天然绿洲的变化规律及其比例,探讨该区人工绿洲和天然绿洲的适宜配比。研究结果表明:(1)1990~2010年,研究区域人工绿洲呈不断扩张,天然绿洲面积不断缩小,人工绿洲替代天然绿洲的趋势。(2)1990~2010年,人工与天然绿洲总面积几乎无差异,面积变化主要是人工绿洲与天然绿洲之间的相互转换。具体表现为:天然草地、林地等向人工绿洲中的耕地、建筑用地转化;同时植被长势衰退:高覆盖草地向中、低覆盖草地转化,中覆盖草地向低覆盖草地转化,灌木林地逐渐退化为草地,低覆盖草地向沙漠转化。(3)人工与天然绿洲面积比例在近20 a呈增加的趋势,在1990,2000,2010年,人工与天然绿洲面积比值分别是1∶9,2∶8,3∶7。     

聚多巴胺-聚乙烯亚胺改性反渗透膜制备与表征

饮用水短缺和水污染问题严重影响着人类和社会的发展。反渗透技术提供了一种高效经济的方法来生产纯水和处理废水,以缓解这个问题。但是,反渗透膜的污染尤其是生物污染严重制约着其高效应用。膜表面改性技术是提升膜抗污染性能的最常用手段,通过多巴胺盐酸盐(DA)在聚酰胺反渗透膜表面自聚,生成超薄聚多巴胺涂层(PDA),进一步利用PDA涂层上的活性基团将聚乙烯亚胺(PEI)接枝到反渗透膜表面,得到稳定持久的PDA-PEI改性反渗透膜。通过对改性膜的XPS测试,亲水性和抗菌性试验,得到以下结论:PDA成功涂层于反渗透膜表面,且PEI成功接枝于PDA涂层表面;PDA-PEI改性增大了膜表面的亲水性,提升了反渗透膜抗污染的能力,使其具有了一定的抗菌能力。     

分流叶片对离心泵内部固液两相流的影响

为了研究分流叶片对离心泵内部固液两相流的影响,建立固液两相流模型,对无分流叶片离心泵和3种带分流叶片的离心泵进行全流道非定常数值模拟。重点分析了添加分流叶片对离心泵外特性、叶片表面压力脉动、叶片表面颗粒体积分数分布、叶片表面颗粒滑移速度的影响。分析结果表明:添加分流叶片以后,离心泵的扬程和效率均有显著的提高,叶片表面的颗粒分布更加均匀,叶片表面颗粒的滑移速度有不同程度的下降,使颗粒对叶片表面的磨损程度得以降低;当分流叶片的进口直径为0.65D2时,叶片出水边处的压力脉动幅值最小,减小了离心泵在运行过程中的振动和噪声。