| 基于ARM的嵌入式打孔机系统研究 |
| |
| 引用本文： | 邵华.基于ARM的嵌入式打孔机系统研究[J].价值工程,2013(32):52-53. |
| |
| 作者姓名： | 邵华 |
| |
| 作者单位： | 宁波城市职业技术学院,宁波315100 |
| |
| 基金项目： | 浙江省教育厅2012年度高校科研项目（项目编号：Y201223158）. |
| |
| 摘 要： | 本文介绍了一种基于ARM的嵌入式打孔机系统的设计方案,该方案采用ARM11作为主控芯片,对模拟CCD进行图像采集,然后通过图像算法进行圆心定位,最后驱动步进电机进行定位与冲孔。经过现场整机测试,该机的各项性能指标均达到了预期设计目标。
|
| 关 键 词： | 打孔机 S3S6410 步进电机 |
The Design of Embedded Positioning Punching Machine Based on ARM |
| |
| SHAO Hua.The Design of Embedded Positioning Punching Machine Based on ARM[J].Value Engineering,2013(32):52-53. |
| |
| Authors: | SHAO Hua |
| |
| Institution: | SHAO Hua ( Ningbo City College of Vocational Technology, Ningbo 315100, China ) |
| |
| Abstract: | This paper describes an embedded positioning punching system which is based on ARM. This system used $3S6410 as the master chip for acquisition and processing the CCD image, adopted the image algorithm to seek out the center location, and drove the Stepping motor for positioning and punching. After testing, the performance of this system can perfectly achieve the aim. |
| |
| Keywords: | positioning punching machine S3S6410 stepping motor |
| 本文献已被 维普 等数据库收录！ |
|
