| 平面曲柄摇杆机构按最小传动角最大和尺寸最小的优化设计 |
| |
| 引用本文： | 吴建华.平面曲柄摇杆机构按最小传动角最大和尺寸最小的优化设计[J].黄石理工学院学报,2000,16(3):19-22. |
| |
| 作者姓名： | 吴建华 |
| |
| 作者单位： | 吴建华（黄石市广播电视大学黄石 435003） |
| |
| 摘 要： | 本文研究在平面曲柄摇杆机构的应用中，仅给定摇杆摇角ψ，而将其长度作为设计变量之一，同时也不给定行程速比系数，而其大小作一定限制，列为约束条件之一，通过调节各构件长度来满足既要求机构最小传动角γｍｉｎ最大，又要求机构尺寸最小的平面曲柄摇杆机构的多维双目标优化设计。
|
| 关 键 词： | 曲柄摇杆机构 最小传动角 机构尺寸 优化设计 |
| 文章编号： | 1008-8245(2000)03-0019-04 |
| 修稿时间： | 2000年5月10日 |
THE OPTIMAL DESIGN OPLANAR CRANK-ROCKER MECHANISM ACCORDING TO MAXIMUM LEAST
TRANSMISSION ANGLE AND MINIMUM DIMENSIONS |
| |
| Wu Jianhua.THE OPTIMAL DESIGN OPLANAR CRANK-ROCKER MECHANISM ACCORDING TO MAXIMUM LEAST
TRANSMISSION ANGLE AND MINIMUM DIMENSIONS[J].Journal of Huangshi Institute of Technology,2000,16(3):19-22. |
| |
| Authors: | Wu Jianhua |
| |
| Abstract: | Under the situation of not granted coefficient of travel speed ratio and by means of adjusting the lengths of each component,this paper discussed the multidimensional double objective optimization design for a planar crank-rocker mechanism by not only satisfying the requirement of a maximum least transmission angle but at the same time also satisfying the demand of a minimum dimension of the mechanism. |
| |
| Keywords: | Crank-rocker mechanism least transmission angle Dimension of the mechanism multidimensional optimization design |
| 本文献已被 CNKI 维普 等数据库收录！ |
